4-3 Accessories: Canopy
The canopy of the late-production Fw190D-9 was the bulged Galland-Haube type. This canopy was made by heat-pressing a PVC sheet over a wooden mold prepared for heat forming. The window frame portions are left intact, and the transparent sections are masked with cellophane tape.
 |
|---|
| Fig. 4-3-1 Canopy mold and heat-pressed canopy |
Editor’s Note (H): The black lines drawn on the canopy indicate where masking tape has been applied. The tape is normally applied in two overlapping layers; after priming and sanding, one layer is removed before the final topcoat is applied.
The Galland-Haube canopy is temporarily fitted on top of the armored headrest support frame.
 |
|---|
| Fig. 4-3-2 Temporary fitting |