Differences

This shows you the differences between two versions of the page.

--- en:authors:omachi-masami:a6m_zero:1956-04 [2025/11/12 11:50] – admin
+++ en:authors:omachi-masami:a6m_zero:1956-04 [2025/11/18 19:42] (current) – admin
@@ Line 1: / Line 1: @@
 ~~NOTOC~~
 {{:en:authors:omachi-masami:a6m_zero:making-rei21.jpg?nolink|}}\\
 Continuing from last month’s article, let us proceed with the explanation.
@@ Line 94: / Line 95: @@
 Install the tailwheel similarly. Fit the gun barrels and pitot. On larger scales (around 1:30), adding the antenna wire increases realism: embed a small tinplate tab atop the fin and run fine copper wire to the mast.
 {{:en:authors:omachi-masami:a6m_zero:making-rei27.jpg?nolink&600|}}
-With drop tanks installed, the model is complete—time to celebrate with a ramune!
+With drop tanks installed, the model is complete—time to celebrate with a ramune!((“Ramune” is a nostalgic Japanese soda; this playful toast closes the project in a warm, era-specific tone.))
-In solid modeling, once you have the order of operations, anyone can succeed. If this article helps you complete your model, please send photos and a report—I look forward to them. Questions are welcome; I will answer in these pages.
-Notes on Figures
+In solid modeling, once you have the order of operations, anyone can succeed. If this article helps you complete your model, please send photos and a report—I look forward to them. Questions are welcome; I will answer in these pages.\\
-Figure 2 (A–D): Engine section partition, cowl-flap seat, exhaust stubs, simple front-row radial representation.\\
+----
-Figure 3: Panel-joint grain and rivet placement guides.\\
+<WRAP center small>
+[[en:authors:omachi-masami:a6m_zero:1956-03|← 1956 March Issue]] ｜
+[[en:authors:omachi-masami:a6m_zero:start|Back to A6M ZERO Index]]
+</WRAP>
-Figure 4–6: Loop antenna, canopy forming/attachment, oil-cooler placement.\\
-Propeller: Spinner and blade assembly as described above.